HP A7340-96002 manual Laser Safety

Page 47

Laser Safety

A. Certification and Classification Information

When equipped with native Fibre Channel adapters, this product contains a laser internal to the small form factor pluggable (SFP) transceiver modules.

In the USA, the SFP module is certified as a Class 1 Laser product, conforming to the requirements contained in Department Of Health and Human Services (DHHS) regulation 21 CFR, Subchapter J. The certification is indicated by a label on the metal SFP housing.

Outside the USA, the SFP is certified as a Class 1 Laser product conforming to requirements contained in IEC 825-1:1993 and EN60825-1:1994, including Amendment 11:1996.

The SFP includes the following certifications:

UL Recognized Component (USA)

CSA Certified Component (Canada)

TUV Certified Component (European Union)

CB Certificate (Worldwide)

The following figure shows the Class 1 information label that appears on the metal housing of the SFP.

CLASS 1 LASER PRODUCT 21 CFR(J)

B. Product Information

Each communications port consists of a transmitter and receiver optical subassembly. The transmitter subassembly contains internally a semiconductor laser diode in the wavelength of either 850 nanometers (shortwave laser) or 1310 nanometers (longwave laser).

Class 1 Laser products are not considered hazardous.

WARNING There are no user maintenance operations, service operations, or adjustments to be performed on the SFP module.

C. Usage Restrictions

Failure to comply with these usage restrictions may result in incorrect operation of the system and points of access may emit laser radiation above the Class 1 limits established by the IEC and U.S. DHHS.

Product Regulatory Information

41

Image 47
Contents Quick start guide Hp surestore fc 1Gb/2Gb switch 16B Warranty Contents Specifications Related Publications UpdatesRevision History Title Part Number Product Description Safety GuidelinesPackage Contents Installing the Switch as a Stand-Alone Unit FC 16B Rack-Mounted Switch Installing the Switch in a RackInstalling the Switch To install the switch in a rack Installing the Rear Rail-Tray Brackets Compaq/Rittal Rack Installing the Tinnerman Clips HP Rack Installing the Rubber Washers Assembling the Outer Rails HP Rack Installing Switch into an HP Rack Quick Start Guide System Components SetupSFP Media Side of the FC 16B SFP Media SidePower Supply Power Supply SideFibre Channel Cable Connections Fabric Operating SystemSFPs Description Configuring and Connecting the SwitchTo configure the FC 16B and connect it to a fabric Gateway Address 172.17.1.1 Enter the new gateway address Quick Start Guide Setup Backing up the Switch Configuration Settings Saving the System Configuration FilesRestoring the System Configuration Settings Next Steps Setting QuickLoop Mode on PortsSetting Up Speed Negotiation HP Surestore Director FC-64 Switch Configuring Supported DevicesHP Surestore VA Switch Status Indicators DiagnosticsLEDs on the SFP Media Side Diagnostics LEDs on the Power Supply Side Are faulty Maintenance and Diagnostic Tests Test Command Description Getting Support Error MessagesService and Support Additional Licenses General SpecificationsEnvironmental Power Supply DimensionsQuick Start Guide Product Regulatory Information Germany Noise Declaration Laser Safety Declaration of Conformity Page Page Page A7340-96002