To support many HP
•For Red Hat Enterprise Linux 5 x86 servers:
◦
◦
◦
◦
◦
perl (required to provide the libperl.so)
libnl (required for QLogic and Emulex drivers)
•For Red Hat Enterprise Linux 5 AMD64/EM64T servers:
◦
◦
◦
◦
◦
perl (required to provide the libperl.so)
libnl (required for QLogic and Emulex drivers)
•For Red Hat Enterprise Linux 5 AMD64/EM64T servers:
◦
◦
◦
◦
◦
perl (required to provide the libperl.so)
libnl (required for QLogic and Emulex drivers)
Minimum requirements for Red Hat Enterprise Linux 6 servers
NOTE: The following versions listed are needed as a minimum. Later versions of these might be used as well.
Ensure that each NIC has an IP address assigned. To get the IP address assigned to a NIC, enter the dhclient command in the console, which enables the NIC interfaces and retrieves an IP address. If a NIC does not have an IP address, HP SUM appears to hang on start up.
•Red Hat Enterprise Linux console mode
No X console in either x86 or x86_64 servers. To run HP SUM in silent mode, you must install the base server with defaults and the following RPMs:
◦
◦
◦
◦
◦
◦
12 Deploying PSPs