HP UX Auto Port Aggregation (APA) Software Example B-1 Sample lanconfig.ascii Configuration File

Example B-1 Sample lanconfig.ascii Configuration File

#*********************************************** #******* LAN MONITOR CONFIGURATION FILE

#*** For complete details about the parameters and how #*** to set them, consult the lanqueryconf(1m) manpage #*** or your manual.

#*** All timeout values are microseconds; they are rounded up #*** or down appropriately. #***********************************************************

#***********************************************

#The valid range for POLLING_INTERVAL: 500,000-10,000,000 usec

#Default value for POLLING_INTERVAL: 10,000,000 usec

#Minimum value for DEAD_COUNT: 2

#Default value for DEAD_COUNT: 3 #**********************************************

POLLING_INTERVAL10000000

DEAD_COUNT3 #***********************************************

#By default, LM_RAPID_ARP is on.

#If LM_RAPID_ARP is on, the valid ranges are:

#LM_RAPID_ARP_INTERVAL: 1000000-4000000 (default:1000000 usec

# LM_RAPID_ARP_COUNT: 5 - 60 (default is 10)

#(LM_RAPID_ARP_INTERVAL * LM_RAPID_ARP_COUNT) <= 60s #**********************************************

LM_RAPID_ARPoff

LM_RAPID_ARP_INTERVAL1000000

LM_RAPID_ARP_COUNT10

# ****************************************************************

#	Note:	**
#		**
# In Proactive Failover, the active port of a fail-over group		**

#is the port with the minimum normalized port cost. This means **

#a fail-over group will change its active port to a ready port **

# having a lower normalized port cost, even when the current	**
# active port remains up. You must use cost-based fail-over	**
# groups in order to get the Proactive Failover behavior.	**
#	**
# To define a cost-based fail-over group, all the ports in the	**
# fail-over group must have a cost defined. Cost has a valid	**
# range of between 1 and 100, inclusive. The value must be	**
# preceded by a colon (:) character.	**
#	**

# If one of the ports in a fail-over group does not have a cost **

# defined, the fail-over group is invalid.					**
#					**
# If all ports in a fail-over group have no cost defined, the					**
# default failover behavior is used. The available port with					**
# the highest priority becomes the active port.					**
#					**
# By default, the lanqueryconf -s command creates only					**
# priority-based fail-over groups.					**
#					**
# Example with cost defined:					**
#	FAILOVER_GROUP	lan903			**
#	STATIONARY_IP	195.55.55.55			**
#	# Pri/Stdby	I/f	Pri	Cost	**
#	PRIMARY	lan900	7	: 1	**
#	STANDBY	lan901	6	: 2	**
#					**
# For more information on how to use proactive fail-over, see					**
# the HP Auto Port Aggregation Administrator's Guide at					**
# http://docs.hp.com.					**

# ****************************************************************

lanconfig.ascii File 101