HP UX Auto Port Aggregation (APA) Software manual Figure D-2 Vlan over a Failover Group

Figure D-2 VLAN over a Failover Group

Failover Group lan902: lan901 (Primary), lan5, 6 (Standby)

Switch1

	Run Atn. Fault	Remote Power
lan901	lan5	lan6

Switch2

Trk4

Vlan 333

Vlan 334

F17 F18

Vlan 333

Vlan 334

As the first step in creating the failover group, associate the ports in link aggregate lan901 to Trk4 on Switch 1; set the trunk type to trunk (MANUAL trunking). Connect ports lan5 and lan6 to ports F17 and F18, respectively, on Switch 2.

To create the VLANs on Switch 1, complete the following steps:

1.Create the VLANs with IDs 333 and 334. Enter:

Switch 1#

Switch 1# configure

Switch 1(config)# vlan 333 name vlan_333 Switch 1(config)# vlan 334 name vlan_334

2.Tag Trk4 to VLANs 333 and 334. Enter:

Switch 1(config)# vlan 333 tagged Trk4 Switch 1(config)# vlan 334 tagged Trk4 Switch 1(config)# exit

Configuring VLANs over Failover Groups 115