HP 355856-001 manual Diskette Drive Bezel

Page 10

Hardware Upgrades

Diskette Drive Bezel

✎Depending on the computer configuration, you may have a bezel blank in this position. If you do not have a drive in this slot, you may choose to install a 3.5-inch device (such as a diskette drive, hard drive, or Zip drive) later on.

Pull the right retaining tab towards the center of the main bezel. At the same time, pull the bezel inwards to remove it from the main bezel.

Removing the Bezel Blank

To install a diskette drive bezel, reverse the removal procedure.

1–6	Hardware Reference Guide

Image 10

Contents Hardware Reference Guide Hardware Reference Guide Contents Electrostatic Discharge Hardware Upgrades Serviceability FeaturesPage Removing the Access Panels Removing the Front Bezel Removing Front Drive Bezels Drive Bezel BlankDiskette Drive Bezel DIMMs Installing Additional MemoryDDR-SDRAM DIMMs Single Channel and Dual Channel Modes Installing Memory Modules Installing a Memory Module Installing an Expansion Card Installing an Expansion Card Replacing or Upgrading a Drive Drive Positions Drive PositionsRemoving a 5.25 Drive Removing a Diskette Drive Removing the Lower Drive Cage Removing the Lower Drive Cage Removing a 3.5 Hard Drive Hardware Upgrades Battery Replacement Replacing the BatteryBattery Replacement Type Inserting a Type 1 Battery Removing a Type 2 Battery Battery Replacement Routine Care & Shipping Information Routine CareSafety Optical Disk Drive PrecautionsCleaning OperationShipping Preparation Routine Care & Shipping Information Electrostatic Discharge Preventing Electrostatic DamageGrounding Methods Index Index-2