HP 355856-001 manual Removing the Front Bezel

Page 8

Hardware Upgrades

5.To remove the front bezel, grasp the bottom of the front panel below the lowest air vent and pull the panel out and up to release it from the chassis.

Removing the Front Bezel

To install the front bezel, insert the top two latches into their respective holes in the chassis and push the bezel in until it is fully seated.

When replacing the front bezel, ensure that the top of the front bezel is flush with the top of the chassis before pressing it into place.

1–4

Hardware Reference Guide

Image 8
Contents Hardware Reference Guide Hardware Reference Guide Contents Electrostatic Discharge Hardware Upgrades Serviceability FeaturesPage Removing the Access Panels Removing the Front Bezel Removing Front Drive Bezels Drive Bezel BlankDiskette Drive Bezel DDR-SDRAM DIMMs Installing Additional MemoryDIMMs Single Channel and Dual Channel Modes Installing Memory Modules Installing a Memory Module Installing an Expansion Card Installing an Expansion Card Replacing or Upgrading a Drive Drive Positions Drive PositionsRemoving a 5.25 Drive Removing a Diskette Drive Removing the Lower Drive Cage Removing the Lower Drive Cage Removing a 3.5 Hard Drive Hardware Upgrades Battery Replacement Replacing the BatteryBattery Replacement Type Inserting a Type 1 Battery Removing a Type 2 Battery Battery Replacement Routine Care & Shipping Information Routine CareOptical Disk Drive Precautions CleaningSafety OperationShipping Preparation Routine Care & Shipping Information Electrostatic Discharge Preventing Electrostatic DamageGrounding Methods Index Index-2