HP 355856-001 manual Removing Front Drive Bezels, Drive Bezel Blank

Page 9

Hardware Upgrades

Removing Front Drive Bezels

1.Turn off the computer properly through the operating system and turn off any external devices.

2.Disconnect the power cord from the power outlet and the computer, and disconnect any external devices.

3.Remove the access panel.

4.Remove the front bezel.

5.25” Drive Bezel Blank

Press one of the retaining tabs on the inside of the large bezel towards the outer edge of the bezel to release the bezel blank. At the same time, pull the bezel blank inwards to remove it from the main bezel.

Removing the Bezel Blank

To install a bezel blank, reverse the removal procedure.

Hardware Reference Guide

1–5

Image 9
Contents Hardware Reference Guide Hardware Reference Guide Contents Electrostatic Discharge Serviceability Features Hardware UpgradesPage Removing the Access Panels Removing the Front Bezel Drive Bezel Blank Removing Front Drive BezelsDiskette Drive Bezel Installing Additional Memory DIMMsDDR-SDRAM DIMMs Single Channel and Dual Channel Modes Installing Memory Modules Installing a Memory Module Installing an Expansion Card Installing an Expansion Card Replacing or Upgrading a Drive Drive Positions Drive PositionsRemoving a 5.25 Drive Removing a Diskette Drive Removing the Lower Drive Cage Removing the Lower Drive Cage Removing a 3.5 Hard Drive Hardware Upgrades Replacing the Battery Battery ReplacementBattery Replacement Type Inserting a Type 1 Battery Removing a Type 2 Battery Battery Replacement Routine Care Routine Care & Shipping InformationCleaning Optical Disk Drive PrecautionsSafety OperationShipping Preparation Routine Care & Shipping Information Preventing Electrostatic Damage Electrostatic DischargeGrounding Methods Index Index-2