HP 355856-001 manual Removing the Lower Drive Cage

Page 22

Hardware Upgrades

7.Remove the four screws that secure the drive cage to the front of the chassis 1 and then remove the single screw that attaches the lower drive cage to the fixed upper drive cage on the right side of the chassis 2.

The HP Compaq d248 Microtower has 3 screw securing the drive cage to the front of the chassis.

8.Slide the lower drive cage back about 1/2 inch to release it from the upper cage 3.

Removing the Lower Drive Cage

To install the lower drive cage, reverse the removal procedure.

ÄCAUTION: When installing the retaining screws always use the short (5/32” long) screw in the side mounting position and the 4 longer screws on the front of the chassis.

1–18

Hardware Reference Guide

Image 22
Contents Hardware Reference Guide Hardware Reference Guide Contents Electrostatic Discharge Hardware Upgrades Serviceability FeaturesPage Removing the Access Panels Removing the Front Bezel Removing Front Drive Bezels Drive Bezel BlankDiskette Drive Bezel DIMMs Installing Additional MemoryDDR-SDRAM DIMMs Single Channel and Dual Channel Modes Installing Memory Modules Installing a Memory Module Installing an Expansion Card Installing an Expansion Card Replacing or Upgrading a Drive Drive Positions Drive PositionsRemoving a 5.25 Drive Removing a Diskette Drive Removing the Lower Drive Cage Removing the Lower Drive Cage Removing a 3.5 Hard Drive Hardware Upgrades Battery Replacement Replacing the BatteryBattery Replacement Type Inserting a Type 1 Battery Removing a Type 2 Battery Battery Replacement Routine Care & Shipping Information Routine CareSafety Optical Disk Drive PrecautionsCleaning OperationShipping Preparation Routine Care & Shipping Information Electrostatic Discharge Preventing Electrostatic DamageGrounding Methods Index Index-2