HP 355856-001 manual Removing a Type 2 Battery

Page 29

Battery Replacement

Type 2:

a.To release the battery from its holder, push the retaining clip that holds the battery in place 1.

a. Lift the battery out of its holder 2.

Removing a Type 2 Battery

b.Slide the replacement battery into position. The battery holder automatically secures the battery in the proper position.

After the battery has been replaced, use the following steps to complete this procedure.

5.Replace the computer cover or access panel.

6.Plug in the computer and turn on power to the computer.

Reset the date and time, your passwords, and any special system setups, using Computer Setup. Refer to the Computer Setup (F10) Utility Guide.

Hardware Reference Guide

2–5

Image 29
Contents Hardware Reference Guide Hardware Reference Guide Contents Electrostatic Discharge Serviceability Features Hardware UpgradesPage Removing the Access Panels Removing the Front Bezel Drive Bezel Blank Removing Front Drive BezelsDiskette Drive Bezel DDR-SDRAM DIMMs Installing Additional MemoryDIMMs Single Channel and Dual Channel Modes Installing Memory Modules Installing a Memory Module Installing an Expansion Card Installing an Expansion Card Replacing or Upgrading a Drive Drive Positions Drive PositionsRemoving a 5.25 Drive Removing a Diskette Drive Removing the Lower Drive Cage Removing the Lower Drive Cage Removing a 3.5 Hard Drive Hardware Upgrades Replacing the Battery Battery ReplacementBattery Replacement Type Inserting a Type 1 Battery Removing a Type 2 Battery Battery Replacement Routine Care Routine Care & Shipping InformationCleaning Optical Disk Drive PrecautionsSafety OperationShipping Preparation Routine Care & Shipping Information Preventing Electrostatic Damage Electrostatic DischargeGrounding Methods Index Index-2