RoHS Compliance, Material Usage

Batteries	This battery(s) in this product comply with EU Directive 2006/66/EC
	Batteries used in the product do not contain:
	Mercury greater the 5ppm by weight
	Cadmium greater than 10ppm by weight

Battery size: CR2032 (coin cell)

Battery type: Li Ion

Additional Information This product is in compliance with the Restrictions of Hazardous Substances (RoHS) directive - 2002/95/EC.

This HP product is designed to comply with the Waste Electrical and Electronic Equipment (WEEE) Directive – 2002/96/EC.

This product is in compliance with California Proposition 65 (State of California; Safe Drinking Water and Toxic Enforcement Act of 1986).

This product is in compliance with the IEEE 1680 (EPEAT) standard at the Silver level, see www.epeat.net

Plastics parts weighing over 25 grams used in the product are marked per ISO 11469 and ISO1043.

This product contains 0% post consumer recycled plastic (by wt.)

This product is 95.1% recyclable when properly disposed of at end of life.

Packaging Materials External
Corrugated Carton	1705 g
Internal
EPE-Expanded Polyethylene	198 g
Polyethylene low density foam	39 g

The EPE-Expanded Polyethylene packaging material is made from 100% recycled content.

The Polyethylene low density foam packaging material is made from 100% recycled content.

The Corrugated Carton packaging materials contains at least 75% recycled content.

RoHS Compliance	Hewlett-Packard is committed to compliance with all applicable environmental laws and
	regulations, including the European Union Restriction of Hazardous Substances (RoHS) Directive.
	HP's goal is to exceed compliance obligations by meeting the requirements of the RoHS Directive
	on a worldwide basis. By July 1, 2006, RoHS substances will be virtually eliminated (virtually = to
	levels below legal limits) for all HP electronic products subject to the RoHS Directive, except
	where it is widely recognized that there is no technically feasible alternative (as indicated by an
	exemption under the EU RoHS Directive).
Material Usage	This product does not contain any of the following substances in excess of regulatory limits (refer
	to the HP General Specification for the
	Environment at http://www.hp.com/hpinfo/globalcitizenship/environment/
	supplychain/gen_specifications.html):

Asbestos

Certain Azo Colorants

Certain Brominated Flame Retardants – may not be used as flame retardants in plastics Cadmium

Chlorinated Hydrocarbons Chlorinated Paraffins Formaldehyde

Halogenated Diphenyl Methanes Lead carbonates and sulfates Lead and Lead compounds Mercuric Oxide Batteries

Nickel – finishes must not be used on the external surface designed to be frequently handled or carried by the user.

Ozone Depleting Substances Polybrominated Biphenyls (PBBs) Polybrominated Biphenyl Ethers (PBBEs)

DA - 13412 Worldwide QuickSpecs — Version 6 — 10/14/2009

Page 43

RoHS Compliance