HP m300 manual Half-Height Bay, Installing a Half-Height Drive

5.9 Half-Height Bay

The expansion base features one standard half-height bay, located on the left side of the expansion base. This bay supports any standard half-height drive, such as a diskette or hard drive.

Installing a Half-Height Drive

1.Prepare the expansion base for disassembly (Section 5.3).

2.Remove the tray (Section 5.4).

3.Remove the connector cover (Section 5.5).

4.Remove the rear bezel (Section 5.6).

5.Remove the top cover (Section 5.8).

6.Remove the three screws ➊ that secure the bezel cage to the base cover (Figure 5-14).

7.Lift the bezel cage out of the base cover ➋.

Figure 5-14.Removing the Bezel Cage

5-14Removal and Replacement Procedures