7.If a half-height device is installed in the half-height bay, disconnect the half height bay power supply cable from the half-height device ➊ (Figure 5-30).
8.Partially remove the power supply from the base cover.
9.Route the half-height bay power supply cable through the opening in the backplane ➋.
10.Remove the power supply from the base cover ➌.
NOTE: In the illustration below, the half-height device is shown removed from the expansion base. In reality, it is not necessary to remove the half-height device to remove the power supply.
Figure 5-30.Removing the Power Supply
Reverse the removal procedure described above to install the power supply.
5-30Removal and Replacement Procedures
