HP E5123A manual Automatic Conﬁguration Parameters, See also

Page 12

To Set Up the Interface Pod

Automatic Conﬁguration Parameters

After you insert the interface pod and connect it to the SUT, the analyzer automatically conﬁgures to the STM-1 electrical signal.

The analyzer sets the remaining physical layer receive and transmit parameters to the following defaults:

	∙	reference (internal) clock
	∙ 20 dB input gain off
	∙	full duplex
See also	User Online Help contains information about the ATM layer automatic
	conﬁguration parameters.

8

Image 12

Contents Setting Up STM-1 Electrical Interface Pod Broadband Service AnalyzerWarranty CopyrightPrinting history Product supportContents What is it? What does it do? About the STM-1 Electrical Interface Pod To Access User Online Help Online HelpOnline Help Access Signal Out Front Panel at a GlanceFront Panel at a Glance To Set Up the Interface Pod To Set Up the Interface PodTo Insert the Interface Pod To Remove the Interface Pod To Connect to the System Under TestReceive Rx Automatic Conﬁguration Parameters See alsoTo Manually Conﬁgure the Interface Pod Click the STM-1 tabWhat to Do Next What to Do NextStandards and Specifications Standards and SpeciﬁcationsCommunications Standards Input and Output Speciﬁcations Error Generation Speciﬁcations Physical SpeciﬁcationsEnvironmental Speciﬁcations Limitation of Warranty CertificationExclusive Remedies Restricted Rights LegendDo not clean with fluids Safety SymbolsKeep away from live Service et ajustement Service non autoriséSymboles des sécurité AvertissementDeclaration of Conformity Page