HP E5123A manual To Set Up the Interface Pod

Page 8

To Set Up the Interface Pod

To Set Up the Interface Pod

Caution	Handle the interface pod with care to avoid electrostatic discharge (ESD)
	damage during unpacking, installation, and operation. The connectors on
	the front and rear of the interface pod are susceptible to ESD.
	1	Insert the interface pod into the analyzer.
		See “To Insert the Interface Pod” on page 5. The procedure is the same for
		all interface pods.
	2	Connect the interface pod to the SUT.
		See “To Connect to the System Under Test” on page 6. The analyzer
		automatically recognizes and conﬁgures the interface pod.
	3	If you want to change any of the conﬁguration parameters, see “To
		Manually Conﬁgure the Interface Pod” on page 9.

4

Image 8

Contents Setting Up STM-1 Electrical Interface Pod Broadband Service AnalyzerWarranty CopyrightPrinting history Product supportContents What is it? What does it do? About the STM-1 Electrical Interface Pod Online Help To Access User Online HelpOnline Help Front Panel at a Glance Access Signal OutFront Panel at a Glance To Set Up the Interface Pod To Set Up the Interface PodTo Insert the Interface Pod To Remove the Interface Pod To Connect to the System Under TestReceive Rx Automatic Conﬁguration Parameters See alsoTo Manually Conﬁgure the Interface Pod Click the STM-1 tabWhat to Do Next What to Do NextCommunications Standards Standards and SpecificationsStandards and Speciﬁcations Input and Output Speciﬁcations Environmental Speciﬁcations Error Generation SpeciﬁcationsPhysical Speciﬁcations Limitation of Warranty CertificationExclusive Remedies Restricted Rights LegendKeep away from live Do not clean with fluidsSafety Symbols Service et ajustement Service non autoriséSymboles des sécurité AvertissementDeclaration of Conformity Page