HP E5123A manual To Manually Conﬁgure the Interface Pod, Click the STM-1 tab

Page 13

To Set Up the Interface Pod

To Manually Conﬁgure the Interface Pod

1From the Configure menu, select the appropriate port; then select Set Up.

2Click the STM-1 tab.

3Select the parameters you require.

4Click to set the configuration

or

Click Auto to set the parameters to the default settings. A message warns you that the reconfiguration will cause some measurements and data to be lost and asks if you want to continue. Click OK.

Note When the configuration is complete, the analyzer updates all relevant screens and windows to reflect the new configuration parameters.

9

Image 13

Contents Broadband Service Analyzer Setting Up STM-1 Electrical Interface PodCopyright WarrantyPrinting history Product supportContents What is it? What does it do? About the STM-1 Electrical Interface Pod Online Help To Access User Online HelpOnline Help Front Panel at a Glance Access Signal OutFront Panel at a Glance To Set Up the Interface Pod To Set Up the Interface PodTo Insert the Interface Pod To Connect to the System Under Test To Remove the Interface PodReceive Rx See also Automatic Conﬁguration ParametersClick the STM-1 tab To Manually Conﬁgure the Interface PodWhat to Do Next What to Do NextStandards and Speciﬁcations Standards and SpecificationsCommunications Standards Input and Output Speciﬁcations Physical Speciﬁcations Error Generation SpeciﬁcationsEnvironmental Speciﬁcations Certification Limitation of WarrantyExclusive Remedies Restricted Rights LegendSafety Symbols Do not clean with fluidsKeep away from live Service non autorisé Service et ajustementSymboles des sécurité AvertissementDeclaration of Conformity Page