HP E5123A manual Contents

Page 3

Contents
Guide to the HP E5200A Broadband Service Analyzer Documentation	iv
About the STM-1 Electrical Interface Pod	1
Online Help	2
To Access User Online Help	2
Front Panel at a Glance	3
To Set Up the Interface Pod	4
To Insert the Interface Pod	5
To Remove the Interface Pod	6
To Connect to the System Under Test	6
Automatic Configuration Parameters	8
To Manually Configure the Interface Pod	9
What to Do Next	10
Standards and Specifications	11
Communications Standards	11
Input and Output Specifications	12
Physical Specifications	13
Environmental Specifications	13
Error Generation Specifications	13

iii

Image 3

Contents Broadband Service Analyzer Setting Up STM-1 Electrical Interface PodProduct support WarrantyCopyright Printing historyContents What is it? What does it do? About the STM-1 Electrical Interface Pod To Access User Online Help Online HelpOnline Help Access Signal Out Front Panel at a GlanceFront Panel at a Glance To Set Up the Interface Pod To Set Up the Interface PodTo Insert the Interface Pod To Connect to the System Under Test To Remove the Interface PodReceive Rx See also Automatic Conﬁguration ParametersClick the STM-1 tab To Manually Conﬁgure the Interface PodWhat to Do Next What to Do NextStandards and Specifications Standards and SpeciﬁcationsCommunications Standards Input and Output Speciﬁcations Error Generation Speciﬁcations Physical SpeciﬁcationsEnvironmental Speciﬁcations Restricted Rights Legend Limitation of WarrantyCertification Exclusive RemediesDo not clean with fluids Safety SymbolsKeep away from live Avertissement Service et ajustementService non autorisé Symboles des sécuritéDeclaration of Conformity Page