7.If it is necessary to replace the display enclosure or any of the display assembly internal components:
a.Remove the Mylar screw covers (1). The screw covers are included in the Display Screw Kit, spare part number
b.Remove the two Phillips PM2.5×5.0 screws (2) that secure the display enclosure to the display assembly.
c.Lift the bottom edge of the display bezel/panel assembly (1) until it rests at a slight angle.
d.Disconnect the logo light cable (2) from the display panel cable.
e.Release the wireless antenna cables (3) from the right display hinge.
f.Remove the display bezel/panel assembly (4).
g.Set the display enclosure aside. The display enclosure is available using spare part number
72 Chapter 4 Removal and replacement procedures | ENWW |