SECTION 5: TROUBLESHOOTING
FIGURE 9: System Control Troubleshooting Chart
If control is not working properly, disconnect power to control and check for signs of physical damage to the front and back of the circuit board, water damage (cor- rosion) or scorching. If damage is found, identify and rectify source of damage. Replace circuit board (P/N 10090101), if it has permanent damage.
Is the line power | No | Check the power supply | |
to the system control | |||
indicator on? | |||
| panel. Is it on? | ||
|
| ||
|
| No | |
|
| Rectify power supply | |
|
| problem. | |
Yes |
|
|
| Check the 250mA |
| Contact | |
Yes | Yes | |||
fuse. Is it OK? | ||||
|
| at | ||
|
|
| ||
| No |
|
| |
| Replace fuse with |
|
| |
| P/N 10000212. |
|
|
Adjust thermostat set |
| Is external wiring to the | |
point to call for heat. | No | ||
Does the pump | pump OK? | ||
| |||
come on? |
|
| |
|
| No | |
|
| Rectify. | |
Yes |
|
| |
Does the zone light | No | Does the pressure switch | |
come on? | light come on? | ||
|
| No | |
|
| Is external wiring to the | |
|
| pressure switch OK? | |
|
| No | |
|
| Rectify. | |
Yes |
|
| |
Do the incorrect zone |
| Are the zone thermostats | |
lights or all zone | Yes | ||
wired correctly? | |||
lights come on? |
| ||
|
| ||
|
| Yes | |
|
| Contact | |
|
| ||
|
| at | |
No |
|
| |
Do the burners in the | No | Is external wiring to the | |
zone come on? | zone OK? | ||
|
| No | |
|
| Rectify. | |
Yes |
|
| |
Do the burners turn off |
| Contact | |
No | |||
when the thermostat is | at | ||
| |||
satisfied? |
|
| |
Yes |
|
| |
Does the pump turn off |
| Contact | |
No | |||
following post purge period? | at | ||
| |||
Yes |
|
| |
Troubleshoot ends. |
|
| |
Contact |
|
| |
|
| ||
at |
|
|
Yes
Yes
No
Yes
Is the correct contactor
selected for the
pump?
No
Fit the correct contactor.
Refer to burner trouble- shooting in either the
CORAYVAC® or
VANTAGE® NP
Installation, Operation and
Service Manuals.
Turn off power and correct
wiring.
Has the system been
commissioned?
Yes
Refer to burner trouble- shooting in either the
CORAYVAC® or
VANTAGE® NP
Installation, Operation and
Service Manuals.
Refer to burner trouble-
Yes | shooting in either the | |
CORAYVAC® or | ||
| ||
| VANTAGE® NP |
Installation, Operation and
Service Manuals.
Is the thermostat connected | No | Rectify. |
Yes to the correct terminal at the | ||
system control. |
|
|
Yes
Contact
at
Refer to the burner start up
No instructions in either the CORAYVAC® or VANTAGE® NP Installation, Operation
and Service Manuals.
13