Wireless remote controller kit | Installation Manual |
|
8 HOW TO SET THE ADDRESS SWITCH
•When the multiple Signal receiving units are installed in the same room, an address can be set to prevent cross communication.
•When replacing the battery and pushing ACL button, the address of the remote controller becomes [ALL] and the Signal receiving unit is enabled to receive signal regardless of setting of address switch of the operation section.
•For selecting of the remote controller address, refer to Owner’s Manual.
•Change the address of the Signal receiving unit by removing screws of P.C. board cover of the Signal receiving unit. After then, fix the cover with screws using a clamp.
Display of remote | Address | Address | Address | Address | ||||
|
|
|
|
|
| |||
controller address |
|
|
|
|
|
| ||
|
|
| Address switch |
|
|
|
|
|
Address switch position | of Signal |
|
|
|
|
| ||
receiving unit |
|
|
|
|
| |||
of Signal receiving unit |
|
|
|
|
| |||
can be set any |
|
|
|
| A | |||
|
|
|
|
|
|
| ||
|
|
| position. |
|
|
|
| |
|
|
|
|
|
|
|
| |
The address switch is inside the cover of Signal receiving |
|
|
| |||||
unit. |
|
|
|
|
|
|
|
|
Contact the dealer for setting of the switch. |
|
|
|
| ||||
Turn the | A | switch to left for 1, 2 and 3, and right for 4, 5 | 4 | 5 | 6 | |||
|
|
|
|
| 1 | 2 | 3 | |
and 6. |
|
|
|
|
| Screw |
|
|
Remove | Face plate |
|
9 SLIDE SWITCH
•Check the slide switch in the battery box of the remote controller is set to [S] / [A] as factory default.
Select of operation mode set to A.
Slide switch position
Select of louver indication set to S.
– 11 – |