Toshiba TCB-AX21UL Case using remote controller mounting to the wall, etc, Replacement of battery

Page 14

Wireless remote controller kit

Installation Manual

 

12 EXPLANATION TO CUSTOMERS

•Hand over the “Owner’s Manual” and “Installation Manuals” to the customer after installation works.

•Explain usage and maintenance of the remote controller according to “Owner’s Manual”.

13 HOW TO HANDLE THE REMOTE CONTROLLER

In case using remote controller mounting to the wall, etc.

Check a signal is received correctly by pushing button at the position to be fixed.

Mounting screw Truss tapping

Ø0.16” x 0.63” (M4 x 16mm) Put on.

Push.

• To take off remote controller, pull it toward you.

Replacement of battery

1.Holding the both ends of the cover and remove it by sliding downward.

2. Correctly insert 2 AAA alkali batteries matching (+) and (-) polarities with indications.

3. Push ACL button with something tipped and

ACL button

Cover

attach the cover.

 

13-EN

– 13 –

Page 13 Page 15
Image 14
Page 13 Page 15
Contents TCB-AX21UL Contents Accessory Parts Switch Location of Signal Receiving Unit Address selector switchInstallation Location of Signal Receiving Unit HOW to Install the Signal Receiving Unit Fig. aFig.B Fig.E Provided wire joint WHT HOW to Perform Cabling of the Signal Receiving UnitConnection diagram To operate an indoor unit by 2 remote controllers RequirementHOW to SET the Room Temperature Sensor Wireless remote controller kitHOW to SET the Address Switch Slide SwitchLamp indication of Signal receiving unit SELF-DIAGNOSIS Table and MeasuresCase using remote controller mounting to the wall, etc Replacement of batteryBefore test run How to conduct a Test RUNTest RUN 85464369216000 EH99677601
Top Page Image Contents