Toshiba TCB-AX21UL installation manual Fig.E

Page 8

Wireless remote controller kit

4.Use bracket parts (A) and (B) to securely grip the ceiling material. (Fig. E)

5.Connect the Signal receiving unit wire (2-core) to the wire from the indoor unit. (Refer to “Wiring the Signal receiving unit.”) Check the terminal number on the indoor unit before wiring the Signal receiving unit and be sure not to wire incorrectly. (The unit will be damaged if high voltage, such as 208/230 VAC, is applied.)

6.Adjust the provided spacers so that they are several millimeters larger than the thickness of the ceiling material. Pass the 2 supplied screws (0.16” x 1.6” (M4 x 40 mm)) through the spacers and tighten them enough to hold the Signal receiving unit in place.

7.Return parts (A) and (B) through the gap between the ceiling and Signal receiving unit so that they are contained in the openings. Then tighten the screws.

Do not tighten the screws excessively. This may result in damage or deformation of the case.

Tighten to the point where the Signal receiving unit can be moved slightly by hand. (Fig. F)

8.Reattach the face plate.

Installation Manual

Part (A)

Part (B)

Fig.E

Fig.F

7-EN

– 7 –

Page 7 Page 9
Image 8
Page 7 Page 9
Contents TCB-AX21UL Contents Accessory Parts Switch Location of Signal Receiving Unit Address selector switchInstallation Location of Signal Receiving Unit HOW to Install the Signal Receiving Unit Fig. aFig.B Fig.E Provided wire joint WHT HOW to Perform Cabling of the Signal Receiving UnitConnection diagram To operate an indoor unit by 2 remote controllers RequirementHOW to SET the Room Temperature Sensor Wireless remote controller kitHOW to SET the Address Switch Slide SwitchLamp indication of Signal receiving unit SELF-DIAGNOSIS Table and MeasuresCase using remote controller mounting to the wall, etc Replacement of batteryBefore test run How to conduct a Test RUNTest RUN 85464369216000 EH99677601
Top Page Image Contents