Wireless remote controller kit | Installation Manual |
|
2 SWITCH LOCATION OF SIGNAL RECEIVING UNIT
Signal receiving unit
| 1 | 2 | 3 |
|
| 4 | 5 | 6 |
|
Screw |
|
|
|
|
Remove | Face plate | Remove the face plate from Signal receiving unit. | ||
Address selector switch
This switch is used to address one of a maximum of six air conditioners that can be controlled by the remote controller.
(Refer to page 11.)
Allx{/NORMAL selector switch
Set this switch to the “NORMAL” position for the normal operation of the air conditioner. When this switch is set to the “Allx{” position, the indoor unit of the air conditioner is turned off.
RCU:SUB/RCU:MAIN selector switch
Set this switch to the “RCU:MAIN” position for normal operation. Refer to page 9 for setting to the “RCU:SUB” position.
PCB CHK switch
This switch is not used and should be set in the position shown in the figure.
TEST RUN switch
This switch is used for test running.
– 3 – |