Toshiba TCB-AX21UL installation manual Installation Location of Signal Receiving Unit

Page 5

Wireless remote controller kit

Installation Manual

 

3 INSTALLATION LOCATION OF SIGNAL RECEIVING UNIT

•Do not install in a location where the air contains oil mist, such as in a kitchen or factory.

•Do not install next to a window, or in any other location directly exposed to sunlight and outside air.

•Do not install nearby devices which can be expected to produce electrical noise, such as elevators, automatic doors, and industrial sewing machines.

•If the Signal receiving unit is installed near a rapid-start type or inverter-type fluorescent lamp (a lamp which does not include a glow lamp), it may not be possible to receive the wireless remote controller signal in some cases. In order to prevent interference from fluorescent lamps, leave a minimum of 6’7” (2 m) between the Signal receiving unit and the fluorescent lamps, and install the Signal receiving unit in a location where it can receive the wireless remote controller signal when the fluorescent lamps are lit.

EN

– 4 –

4-EN

Page 4 Page 6
Image 5
Page 4 Page 6
Contents TCB-AX21UL Contents Accessory Parts Address selector switch Switch Location of Signal Receiving UnitInstallation Location of Signal Receiving Unit Fig. a HOW to Install the Signal Receiving UnitFig.B Fig.E Provided wire joint WHT HOW to Perform Cabling of the Signal Receiving UnitConnection diagram Requirement To operate an indoor unit by 2 remote controllersWireless remote controller kit HOW to SET the Room Temperature SensorSlide Switch HOW to SET the Address SwitchSELF-DIAGNOSIS Table and Measures Lamp indication of Signal receiving unitReplacement of battery Case using remote controller mounting to the wall, etcBefore test run How to conduct a Test RUNTest RUN 85464369216000 EH99677601
Top Page Image Contents