HP 435, 433 Wrong, Date and/or, Time is, Shown, Date & Time option in the Setup, Respond, Button

Problem	Possible cause	Solution
The wrong	The batteries	The date and time will be
date and/or	died or were	maintained for about 10 minutes
time is	removed from	without batteries installed. Reset
shown.	the camera for	the date and time by using the
	too long.	Date & Time option in the Setup
		menu. (See page 58)
The camera	The camera is	Turn on the camera, or turn it off
does not	turned off or	and then on again.
respond	has shut down.
when I press
	The camera is	Most of the camera buttons,
a button.
	connected to a	except for the lens cover/power
	computer.	switch, do not respond when the
		camera is connected to a
		computer. If they respond, it is
		only to turn the Image Display on
		if it is off, or, in some cases, turn
		the Image Display off if it is on.
	The batteries	Replace or recharge the batteries.
	are drained.
	Images in the	Remove the memory card.
	memory card
	may be
	corrupted.
	The camera	Open the battery/memory card
	has stopped	door and then close it. This should
	operating.	reset the camera.

Chapter 7: Troubleshooting and support 67