Toshiba RAS-10GAVP-E Setting the remote controller, Setting the selector switch on the main unit

	Item	Operation flow and applicable data, etc.			Description
17. Select switch on					1. Purpose
	remote controller				This operation is to operate only one
					indoor unit using one remote controller.
					2. Description
	Press the operation button
					When operating one indoor unit in a
	on the remote controller.				situation where two indoor units have
					been installed in the same room or
					nearby rooms, this operation prevents the
					remote controller signal from being
				Select “B” as the setting for
			YES		received simultaneously by both units,
	Both indoor units			one of the two indoor units and	thus preventing both units from operating.
	start operation.			for the remote controller.
	NO			(See below for details.)	3. Operation
					The indoor unit on which the remote
					controller selection has been set to B
					receives the signal of the remote control-
	Unnecessary set
					ler also set to B.
	[Remote controller select]				(At the factory the remote controller
					selection is set to A on all the indoor
					units. There is no A setting display.)

HiPOWER	ECO		MEMO
			1.3.5.9H
SWING	FIX	FAN	SLEEP	Jumper wire
CLR			SET
CLOCK	ON	OFF
RESET
	CHECK

Cutting direction

Setting the remote controller

Switching between A and B is enabled by cutting the jumper wire inside the battery box using pliers.

1)Slide open the remote controller cover and remove the batteries.

2)Cut the jumper wire inside the battery compartment using nippers.

•The jumper wire should not remain in contact after being cut. Also, be careful not to let plastic scraps, jumper wire cuttings or other debris enter the inside of the remote controller.

3)Insert the batteries. “B” appears in the remote controller display.

* Even after the jumper wire has been cut, switching between A and B is still possible by pressing the CHECK button and FIX button together.

The A or B setting, which was switched by pressing the CHECK button and FIX button together, is restored to the setting established prior to the switching when the battery is replaced or the RESET button is pressed.

Setting the selector switch on the main unit

•Remove the front panel, and then set the selector switch to “B”.

•After making the switch setting, remount the front panel.

Position of remote controller selector switch

When switching between settings “A” and “B”, always switch the indoor unit board and the remote controller as a pair. (Otherwise, the indoor unit will not accept the remote controller’s signals.)

Selector switch

– 41 –