Toshiba RAV-SM802XT-E Operation Description, When power supply is reset, Operation mode selection

FILE NO. SVM-06012

8. OPERATION DESCRIPTION

8-1. When power supply is reset

(1)Distinction of outdoor units

When the power supply is reset, the outdoors are distinguished, and control is exchanged according to the distinguished result.

(2)Setting of the indoor fan speed

Based on EEPROM data, rspeed of the indoor fan is selected.

Remarks: Air speed

8-2. Operation mode selection

(1)Based on the operation mode selecting command from the remote control, the operation mode is selected.

	Table 8-2-1
Remote control	Outline of control
command
STOP	Air conditioner stops.
FAN	Fan operation
COOL	Cooling operation
DRY	Dry operation
HEAT	Heating operation
AUTO	Automatic operation

(2)Automatic Operation

•The air conditioner selects and operates in one of the operating modes of cooling, heating or fan only, depending on the room temperature.

•If the AUTO mode is uncomfortable, you can select the desired conditions manually.

8-3. Air volume control

(1)Operation with [HIGH (H)], [MED (M)], [LOW (L)], or [AUTO] mode is performed by the command from the remote control.

(2)When [FAN] button is set to AUTO, the indoor fan motor operates as shown in Fig. 8-3-1, Fig. 8-3-2 and Table 8-3-1.

<COOL>

temp.)		° C
	+3
(Preset		M+
	+2.5
	*1
	+2
−	*1
temp.)
	*1
	+1.5
(Room	+1
	+0.5
Preset		0
temp.	− 0.5

NOTE :

*1: The values marked with *1 are calculated and controlled by the difference in motor speed between M+ and L–.

Fig. 8-3-1

		Table 8-2-2
Room temperature in operation			Operating condition
The set temperature +1°C or higher	Cooling		Performs the cooling operation at a temperature 1°C
(in case that the room is hot)	operation		higher than the setting.
The set temperature –1°C to +1°C	Fan only		Performs the fan only operation (low speed) while
	operation		monitoring the room temperature. When the room
			temperature changes, the air conditioner will select the
			cooling or heating mode.
The set temperature –1°C or lower	Heating		Performs the heating operation at a temperature 1°C
(in case that the room is cold)	operation		lower than the setting.

– 16 –