4.Lift up on the hard drive tab (3) to remove the hard drive (4) from the hard drive bay.
5.If it is necessary to disassemble the hard drive, perform the following steps:
a.Position the hard drive with the connector toward you.
b.Disconnect the hard drive connector cable (1) from the hard drive.
c.Remove the four Phillips PM3.0×3.5 screws (2) that secure the hard drive bracket to the hard drive.
d.Remove the hard drive bracket (3) from the hard drive.
The hard drive bracket, hard drive connector cable, and screws are available in the Hard Drive Hardware Kit, spare part number
Reverse this procedure to reassemble and install the hard drive.
28 Chapter 4 Removal and replacement procedures