Display panel cable
Description | Spare part number |
|
|
Display panel cable | |
|
|
|
|
Before removing the display panel cable, follow these steps:
1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect the power from the computer by unplugging the power cord from the computer.
3.Disconnect all external devices from the computer.
4.Remove the bottom cover (see Bottom cover on page 23).
5.Remove the rear cover (see Rear cover on page 26).
6.Disconnect the battery cable (see Hard drive on page 27).
7.Remove the hard drive (see Hard drive on page 27).
8.Remove the cover bracket (see X-axis capacitor board on page 33).
9.Remove the display stand recess (see Display stand recess on page 41).
10.Remove the air flow channel (see Air flow channel on page 51).
Remove the display panel cable:
1.Release the adhesive strip (1) that secures the display panel cable to the display assembly.
2.Disconnect the display panel cable (2) from the display panel.
3.Remove the display panel cable (3).
4.Remove the display panel cable.
Reverse this procedure to install the display panel cable.
52 Chapter 4 Removal and replacement procedures