Fan
Description | Spare part number |
|
|
Fan (includes cable and mylar shroud) | |
|
|
Before removing the fan, follow these steps:
1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect the power from the computer by unplugging the power cord from the computer.
3.Disconnect all external devices from the computer.
4.Remove the bottom cover (see Bottom cover on page 23).
5.Remove the rear cover (see Rear cover on page 26).
6.Disconnect the battery cable (see Hard drive on page 27).
7.Remove the hard drive (see Hard drive on page 27).
8.Remove the cover bracket (see X-axis capacitor board on page 33).
9.Remove the display stand recess (see Display stand recess on page 41).
Remove the fan:
1.Disconnect the fan cable (1) from the system board.
2.Detach the mylar shroud (2) that connects the fan to the air flow channel.
3.Remove the three Phillips PM3.0×6.5 screws (3) that secure the fan to the middle frame.
4.Remove the fan (4).
Reverse this procedure to install the fan.
Component replacement procedures 53