4.Remove the right speaker (4) and cable.
5.Release the power connector cable from the clip (1) built into the left speaker/subwoofer.
6.Disconnect the left speaker/subwoofer cable (2) from the system board.
7.Release the left speaker/subwoofer cable from the clips (3) built into the middle frame.
8.Remove the three Phillips PM3.0×6.5 screws (4) that secure the left speaker/subwoofer to the middle frame.
NOTE: The left speaker/subwoofer includes three rubber isolators that are installed in the screw holes (5). These isolators are crucial to the performance of the subwoofer.
9.Remove the left speaker/subwoofer (6) and cable.
Reverse this procedure to install the speakers.
40 Chapter 4 Removal and replacement procedures