Initializing Non-Volatile RAM

Installing the Memory Module

5.If the HP or Compaq screen is displayed, continue to “Initializing Non-Volatile RAM” on page 16. If the HP or Compaq screen is not displayed, proceed to “Setting the Library for HP Mode” on page 16.

To initialize non-volatile RAM:

1.Press the Service tab on the GUI.

2.If prompted, enter the Service password and press Enter. The GUI displays the Service screen.

Note: The default Service password is 5678.

3.Press the Initialize Nonvol Config button.

4.Press the Continue button when prompted. The library initializes non-volatile memory.

5.Proceed to “Changing the Library Settings” on page 18.

Setting the Library for HP Mode

If the library does not display the HP or Compaq screen after completing the steps under “Turning the Library On” on page 15, use the following procedure to set the library for HP mode. The Libdiag utility is used in this procedure. For details on using this utility, refer to the StorageWorks by Compaq ESL9000/TL800 Series

Tape Library Diagnostic Software Guide, available from

http://www.hp.com/support.

Starting Libdiag

To start Libdiag:

1.Connect a PC to the library diagnostic port using a RS-232 cable.

2.Make sure that the library is in the stand by mode.

3.Double-click the diagnostic icon.

4.Select 9600 baud.

5.Select the appropriate Com port (default is com1).

16	HP StorageWorks ESL9000 Series Tape Library Memory Module Upgrade Guide