QuickSpecs
HP SAS Hard Drives
Technical Specifications
SAS Hot Plug LFF (3.5-inch) Midline (MDL) Drives
Application | SAS Midline drives are intended for servers and storage solutions where high capacities are required. | ||
| These drives have | ||
| applications, such as disk backup, archival, and reference applications. | ||
|
| ||
Transfer rate | The components of a storage subsystem (e.g. the drive, the HBA/controller, firmware, and the server | ||
| backplane) should operate at the same data transfer rate or the system bandwidth will be negotiated | ||
| down to an acceptable level for all components. |
| |
|
|
|
|
HP 4TB 6G SAS 7.2K rpm | Capacity | 4,000,787MB | |
LFF |
| Height | 1.04 in (26.4 mm) |
Warranty Hard Drive |
| ||
| Width | 4.36 in (110.7 mm) | |
|
| ||
|
| Depth | 7.43 in (188.7 mm) |
|
| Interface | SAS |
|
| Transfer Rate | 6 Gb/sec |
|
| Synchronous (Maximum) |
|
Seek Time
(typical reads, including settling)
Physical Configuration
Operating Temperature
(System Inlet Air
Temperature)
Single Track | 0.7 ms |
Average | 8.5 ms |
15.7 ms | |
Rotational Speed | 7,200 rpm |
Bytes/Sector | 512 |
Logical Blocks | 7,814,037,168 |
50° to 95° F (10° to 35° C) |
|
NOTE: To support HP hard drives exceeding 2.2 TB, HP Smart Array Firmware version 5.0 or later is required for the following controllers:
HP Smart Array P212 Controller
HP Smart Array P410 Controller
HP Smart Array P411 Controller
HP Smart Array P711m Controller
HP Smart Array P812 Controller
To use hard drives exceeding 2.2 TB, you must create a boot volume using offline ACU version 8.75 or later. HP Smart Array controllers do not support boot volumes exceeding 2.2 TB. Other controllers are not supported
DA - 12244 Worldwide — Version 44 — December 9, 2013 | Page 24 |