QuickSpecs
HP SAS Hard Drives
Technical Specifications
HP 3TB 6G SAS 7.2K rpm |
| Capacity | 3,000,592,982,016 |
LFF |
| Height | 1.04 in (26.4 mm) |
Warranty Hard Drive |
| ||
| Width | 4.36 in (110.7 mm) | |
|
| ||
|
| Depth | 7.43 in (188.7 mm) |
|
| Interface | SAS |
|
| Transfer Rate | 6 Gb/sec |
|
| Synchronous (Maximum) |
|
Seek Time
(typical reads, including settling)
Physical Configuration
Operating Temperature
(System Inlet Air
Temperature)
Single Track | 0.5 ms |
Average | <8.1 ms |
15.5 ms | |
Rotational Speed | 7,200 rpm |
Bytes/Sector | 512 |
Logical Blocks | 5,860,533,168 |
50° to 95° F (10° to 35° C) |
|
NOTE: To support HP hard drives exceeding 2.2 TB, HP Smart Array Firmware version 5.0 or later is required for the following controllers:
HP Smart Array P212 Controller
HP Smart Array P410 Controller
HP Smart Array P411 Controller
HP Smart Array P711m Controller
HP Smart Array P812 Controller
To use hard drives exceeding 2.2 TB, you must create a boot volume using offline ACU version 8.75 or later. HP Smart Array controllers do not support boot volumes exceeding 2.2 TB. Other controllers are not supported
HP 2TB 6G SAS 7.2K rpm | Capacity | 2,000,398,934,016 |
| |
LFF |
| Height | 1.04 in (26.4 mm) |
|
Midline 1yr Warranty Hard |
|
| ||
| Width | 4.36 in (110.7 mm) |
| |
Drive |
|
| ||
| Depth | 7.43 in (188.7 mm) |
| |
|
|
| ||
|
| Interface | SAS |
|
|
| Transfer Rate | 6 Gb/sec |
|
|
| Synchronous (Maximum) |
|
|
|
| Seek Time | Single Track | 0.5 ms |
|
| (typical reads, including | Average | 8.5 ms |
|
| settling) | 16.2 ms | |
|
|
| ||
|
|
| Rotational Speed | 7,200 rpm |
|
| Physical Configuration | Bytes/Sector | 512 |
|
|
| Logical Blocks | 3,907,029,168 |
DA - 12244 Worldwide — Version 44 — December 9, 2013 | Page 25 |