4.Install the heatsink. Insert both screws, and then alternate tightening until the heatsink is seated properly.
5.Install the access panel ("Access panel" on page 24).
6.Install the server blade.
Processor
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to cool before touching them.
CAUTION: To prevent possible server malfunction, do not mix processors of different speeds or cache sizes. Refer to the label on the processor heatsink for a description of the processor.
CAUTION: To prevent possible server blade overheating, always populate each processor socket with a processor socket cover and a heatsink blank or a processor and a heatsink.
IMPORTANT: Processor socket 1 must always be populated. If processor socket 1 is empty, the server blade does not power up.
To remove the component:
1.Power down the server blade (on page 23).
2.Remove the server blade (on page 23).
3.Remove the access panel ("Access panel" on page 24).
4.Remove the heatsink ("Heatsink" on page 30).