HP 7410xi, 2710xi manual HP all-in-one Network Guide

ePress 2 to select WEP encryption.

OR

Press 3 to select WPA encryption.

5If prompted, enter your WPA or WEP key. Use the arrow buttons to highlight a letter or number on the visual keyboard, and then press OK to select it.

Note You must enter the exact uppercase (capital) and lowercase (small) letters. Otherwise, the wireless connection will fail.

If a message says you entered an invalid WPA or WEP key, check the key you wrote down for your new network, and then re-enter the key.

6When you are finished entering the WPA or WEP key, use the arrow buttons to highlight Done on the visual keyboard, and then press OK.

7Press OK to confirm.

The HP all-in-one will attempt to connect to the network. If the connection fails, follow the prompts to correct the key, and then try again. See also, Network troubleshooting

8When the HP all-in-one connects successfully to the network, go to your computer to install the software. See Install the software.