HP DreamColor Z24x Professional Display manual Setting Up the Monitor

Page 13

3 Setting Up the Monitor

To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other attached devices, then follow the instructions below.

NOTE: Be sure the master power switch, located on the rear panel of the monitor, is in the off position. The master power switch turns off all power to the monitor.

Use Caution When Setting Up the Monitor

To prevent damage to the monitor, do not touch the surface of the LCD panel. Pressure on the panel may cause non-uniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover to its normal condition.

If installing a base, lay the monitor face down on a flat surface covered with a protective sheet foam or non-abrasive cloth. This prevents the screen from getting scratched, defaced or broken as well as damage to the front panel buttons.

NOTE: Your monitor may look different from the monitor in this illustration.

Use Caution When Setting Up the Monitor 5

Image 13

Contents HP DreamColor Z24x Display Hewlett-Packard Development Company, L.P About This Guide Iv About This Guide Table of contents Z24x Model Recognizing Preset Display Resolutions Vii Viii Z24x Display Product FeaturesPage Important Safety Information Safety and Maintenance GuidelinesCleaning the Monitor Maintenance GuidelinesShipping the Monitor Use Caution When Setting Up the Monitor Setting Up the MonitorInstalling the Stand Component Function Rear ComponentsConnecting the Cables Page Page Page Page Front Panel Controls Adjusting the Monitor Page Setting Up the Monitor Turning on the Monitor HP Watermark and Image Retention Policy Connecting USB DevicesRemoving the Monitor Stand Mounting the Monitor Page Page Page Locating the Information Card Locating the Serial Number and Product NumberInstalling a Cable Lock Software and Utilities Operating the MonitorInformation File Image Color Matching FileUsing Picture-in-Picture PIP and Picture-beside-Picture PBP Installing the .INF and .ICM FilesInstalling from the Disc Downloading from the InternetDisplayPort Multistreaming Using Auto-Sleep Mode Adjusting the Bezel Button LEDsChanging the Bezel Button Functions Using the On-Screen Display Menu Level DVI Hdmi Primary / PIP Source Information Operating the Monitor Back Factory Reset Color Management Color PresetsColor Calibration Factory Color Calibration UserAuto Edid Update Z24x Model Technical SpecificationsPreset Pixel Format Aspect Ratio Vert Freq Hz Pixel Clk MHz Recognizing Preset Display ResolutionsSolving Common Problems Support and TroubleshootingPreparing to Call Technical Support Product SupportPage Federal Communications Commission Notice Agency Regulatory NoticesModifications CablesAvis Canadien Canadian NoticeEuropean Union Regulatory Notice Japanese Power Cord Requirements Japanese Notice Korean Notice Power Cord Set RequirementsGerman Ergonomics Notice Energy Star Qualification Product Environmental NoticesMaterials Disposal Product Environmental Notices Ukraine Restriction of Hazardous Substances Turkey EEE RegulationLCD Monitor Quality and Pixel Policy