HP DreamColor Z24x Professional Display manual Auto Edid Update

Page 45

calibration software is a Windows-based application that requires use of the Windows 7 or later operating system. The calibration process uses the following steps:

1.Insert the monitor documentation disc into the host computer’s CD/DVD player.

2.Install the user calibration program on the host computer.

3.Place the colorimeter from the DreamColor Calibration Solutions kit in front of the monitor panel as directed.

4.Run the calibration software and follow the on-screen steps. One color space can be calibrated and named at a time. Two methods of calibration are possible:

●Wizard mode – the application will ask questions about the user’s environment and usage then will suggest settings to be used.

●Expert mode – the user will be asked to input all the variables intended for use in the calibration process.

When calibration is complete, the values are saved in monitor memory. The most recent calibration settings can be re-applied at any time through the On-Screen Display.

Auto EDID Update

By default, the display automatically updates the display EDID when you switch color spaces.

If Auto EDID Update is enabled, the EDID will be updated for all inputs every time you change the active color space preset. If Auto EDID Update is disabled, each input will be set to the factory default values for the Native color space.

You can enable or disable Auto EDID Update in the OSD:

1.Press any of the five front bezel buttons on the right side of the front bezel to activate the buttons.

2.Press the bottom Open Menu button to open the OSD.

3.In the OSD, select Management > Auto EDID Update and then select either Enable or Disable.

Color Management 37

Image 45

Contents HP DreamColor Z24x Display Hewlett-Packard Development Company, L.P About This Guide Iv About This Guide Table of contents Z24x Model Recognizing Preset Display Resolutions Vii Viii Z24x Display Product FeaturesPage Important Safety Information Safety and Maintenance GuidelinesMaintenance Guidelines Cleaning the MonitorShipping the Monitor Use Caution When Setting Up the Monitor Setting Up the MonitorInstalling the Stand Component Function Rear ComponentsConnecting the Cables Page Page Page Page Front Panel Controls Adjusting the Monitor Page Setting Up the Monitor Turning on the Monitor HP Watermark and Image Retention Policy Connecting USB DevicesRemoving the Monitor Stand Mounting the Monitor Page Page Page Locating the Information Card Locating the Serial Number and Product NumberInstalling a Cable Lock Software and Utilities Operating the MonitorInformation File Image Color Matching FileUsing Picture-in-Picture PIP and Picture-beside-Picture PBP Installing the .INF and .ICM FilesInstalling from the Disc Downloading from the InternetDisplayPort Multistreaming Adjusting the Bezel Button LEDs Using Auto-Sleep ModeChanging the Bezel Button Functions Using the On-Screen Display Menu Level DVI Hdmi Primary / PIP Source Information Operating the Monitor Back Factory Reset Color Management Color PresetsColor Calibration Factory Color Calibration UserAuto Edid Update Z24x Model Technical SpecificationsPreset Pixel Format Aspect Ratio Vert Freq Hz Pixel Clk MHz Recognizing Preset Display ResolutionsSolving Common Problems Support and TroubleshootingPreparing to Call Technical Support Product SupportPage Federal Communications Commission Notice Agency Regulatory NoticesModifications CablesCanadian Notice Avis CanadienEuropean Union Regulatory Notice Japanese Notice Korean Notice Power Cord Set Requirements Japanese Power Cord RequirementsGerman Ergonomics Notice Product Environmental Notices Energy Star QualificationMaterials Disposal Product Environmental Notices Ukraine Restriction of Hazardous Substances Turkey EEE RegulationLCD Monitor Quality and Pixel Policy