HP DreamColor Z24x Professional Display manual Removing the Monitor Stand

Page 27

Removing the Monitor Stand

You can remove the monitor panel from the stand to install the panel on a wall, a swing arm, or other mounting fixture.

CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnected. Also disconnect any other cables connected to the monitor.

1.Disconnect and remove the signal, power, and USB cables from the monitor.

2.Lay the monitor face down on a flat surface covered by a clean, dry cloth.

3.Press down on the latch near the bottom center of the monitor to unlock the HP Quick Release 2

(1).

4.Swing the bottom of the stand up until the mounting plate clears the recess in the panel (2).

5.Slide the stand out of the recess (3).

Removing the Monitor Stand 19

Image 27

Contents HP DreamColor Z24x Display Hewlett-Packard Development Company, L.P About This Guide Iv About This Guide Table of contents Z24x Model Recognizing Preset Display Resolutions Vii Viii Z24x Display Product FeaturesPage Important Safety Information Safety and Maintenance GuidelinesMaintenance Guidelines Cleaning the MonitorShipping the Monitor Use Caution When Setting Up the Monitor Setting Up the MonitorInstalling the Stand Component Function Rear ComponentsConnecting the Cables Page Page Page Page Front Panel Controls Adjusting the Monitor Page Setting Up the Monitor Turning on the Monitor HP Watermark and Image Retention Policy Connecting USB DevicesRemoving the Monitor Stand Mounting the Monitor Page Page Page Locating the Information Card Locating the Serial Number and Product NumberInstalling a Cable Lock Image Color Matching File Operating the MonitorSoftware and Utilities Information FileDownloading from the Internet Installing the .INF and .ICM FilesUsing Picture-in-Picture PIP and Picture-beside-Picture PBP Installing from the DiscDisplayPort Multistreaming Adjusting the Bezel Button LEDs Using Auto-Sleep ModeChanging the Bezel Button Functions Using the On-Screen Display Menu Level DVI Hdmi Primary / PIP Source Information Operating the Monitor Back Factory Reset Color Calibration User Color PresetsColor Management Color Calibration FactoryAuto Edid Update Z24x Model Technical SpecificationsPreset Pixel Format Aspect Ratio Vert Freq Hz Pixel Clk MHz Recognizing Preset Display ResolutionsSolving Common Problems Support and TroubleshootingPreparing to Call Technical Support Product SupportPage Cables Agency Regulatory NoticesFederal Communications Commission Notice ModificationsCanadian Notice Avis CanadienEuropean Union Regulatory Notice Japanese Notice Korean Notice Power Cord Set Requirements Japanese Power Cord RequirementsGerman Ergonomics Notice Product Environmental Notices Energy Star QualificationMaterials Disposal Product Environmental Notices Ukraine Restriction of Hazardous Substances Turkey EEE RegulationLCD Monitor Quality and Pixel Policy