HP DreamColor Z24x Professional Display manual Installing the Stand

Page 14

Installing the Stand

CAUTION: Do not touch the surface of the LCD panel. Pressure on the panel may cause non- uniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover to its normal condition.

The display uses the HP Quick Release 2 for easy moving of the monitor. To mount the panel onto the stand:

1.Lay the monitor panel face down on a flat surface covered by a clean, dry cloth.

2.Slide the top of the mounting plate (1) on the stand under the upper lip of the recess in the back of the panel.

3.Lower the bottom of the stand's mounting plate (2) into the recess until it snaps into place.

4.The HP Quick Release 2 latch (3) pops up when the stand is locked in place.

NOTE: If you are mounting the monitor to a mounting fixture instead of the stand refer to Mounting the Monitor on page 20.

6 Chapter 3 Setting Up the Monitor

Image 14

Contents HP DreamColor Z24x Display Hewlett-Packard Development Company, L.P About This Guide Iv About This Guide Table of contents Z24x Model Recognizing Preset Display Resolutions Vii Viii Product Features Z24x DisplayPage Safety and Maintenance Guidelines Important Safety InformationShipping the Monitor Maintenance GuidelinesCleaning the Monitor Setting Up the Monitor Use Caution When Setting Up the MonitorInstalling the Stand Rear Components Component FunctionConnecting the Cables Page Page Page Page Front Panel Controls Adjusting the Monitor Page Setting Up the Monitor Turning on the Monitor Connecting USB Devices HP Watermark and Image Retention PolicyRemoving the Monitor Stand Mounting the Monitor Page Page Page Locating the Serial Number and Product Number Locating the Information CardInstalling a Cable Lock Information File Operating the MonitorSoftware and Utilities Image Color Matching FileInstalling from the Disc Installing the .INF and .ICM FilesUsing Picture-in-Picture PIP and Picture-beside-Picture PBP Downloading from the InternetDisplayPort Multistreaming Changing the Bezel Button Functions Adjusting the Bezel Button LEDsUsing Auto-Sleep Mode Using the On-Screen Display Menu Level DVI Hdmi Primary / PIP Source Information Operating the Monitor Back Factory Reset Color Calibration Factory Color PresetsColor Management Color Calibration UserAuto Edid Update Technical Specifications Z24x ModelRecognizing Preset Display Resolutions Preset Pixel Format Aspect Ratio Vert Freq Hz Pixel Clk MHzSupport and Troubleshooting Solving Common ProblemsProduct Support Preparing to Call Technical SupportPage Modifications Agency Regulatory NoticesFederal Communications Commission Notice CablesEuropean Union Regulatory Notice Canadian NoticeAvis Canadien German Ergonomics Notice Japanese Notice Korean Notice Power Cord Set RequirementsJapanese Power Cord Requirements Materials Disposal Product Environmental NoticesEnergy Star Qualification Product Environmental Notices Turkey EEE Regulation Ukraine Restriction of Hazardous SubstancesLCD Monitor Quality and Pixel Policy