Omega Vehicle Security OM5-C manual OM5-IMV/IV, Analog Voltage Input Modules, Narrow Bandwidth

OM5-IMV/IV

Analog Voltage Input Modules, Narrow Bandwidth

FEATURES

●ACCEPTS MILLIVOLT AND VOLTAGE LEVEL SIGNALS

●HIGH LEVEL VOLTAGE OUTPUTS

●1500Vrms TRANSFORMER ISOLATION

●ANSI/IEEE C37.90.1-1989 TRANSIENT PROTECTION

●INPUT PROTECTED TO 240VAC CONTINUOUS

●160dB CMR

●95dB NMR AT 60Hz, 90dB at 50Hz

●±0.05% ACCURACY

●±0.02% LINEARITY

●±1∝V/°C DRIFT

●CSA CERTIFIED, FM APPROVED, CE COMPLIANT

●MIX AND MATCH OM5 TYPES ON BACKPANELS

DESCRIPTION

Each OM5-IMV and OM5-IV voltage input module provides a single channel of analog input which is filtered, isolated, amplified, and converted to a high level analog voltage output (Figure 1). This voltage output is logic-switch controlled, allowing these modules to share a common analog bus without the requirement of external multiplexers.

The OM5 modules are designed with a completely isolated computer side circuit which can be floated to ±50V from Power Common, pin 16. This complete isolation means that no connection is required between I/O Common and Power Common for proper operation of the output switch. If desired, the output switch can be turned on continuously by simply connecting pin 22, the Read-Enable pin to I/O Common, pin 19.

Signal filtering is accomplished with a six-pole filter which provides 95dB of normal-mode-rejection at 60Hz and 90dB at 50Hz. Two poles of this filter are on the field side of the isolation barrier, and the other four are on the computer side.

After the initial field-side filtering, the input signal is chopped by a proprietary chopper circuit. Isolation is provided by transformer coupling, again using a proprietary technique to suppress transmission of common mode spikes or surges. The module is powered from +5VDC, ±5%.

A special input circuit on the OM5-IMV and OM5-IV modules provides protection against accidental connection of power-line voltages up to 240VAC.

+EXC		4
	4	NC		LPF	Isochopper™		20
					Amplifier	LPF		VOUT
+In		6	Surge
					Pat Pending
	3		Suppression
VIN			and				19
		5						I/O Common
			Protection		+V	–V
–In
	2
		3
–EXC							22
		NC			Isolated			RD EN\
	1
					Computer-Side
					Power
Backpanel
Term Block
		1	NC
		2	NC
							17
			+V					+5V
					Isolated
						Power
			–V		Field-Side
						Oscillator
					Power		16
								Power Common
FIGURE 1. OM5-IMV/IV Block Diagram.

4