Omega Vehicle Security OM5-C manual Model, OM5-IAC-1B-C

Page 42

SPECIFICATIONS Typical at TA = +25°C and +5V power.

Module

OM5-IAC

 

 

Input

 

Signal Range

100mV to 10V rms, 0 to 5A rms

Standard Frequency Range

45Hz to 1000Hz

Extended Frequency Range

1kHz to 20kHz

Impedance

1 MΩ ±1% shunted by 100pF (-01 thru -05),

 

0.05Ω ±1% (-06, -07)

Coupling

AC

Protection(1)

 

Continuous

480V (Peak AC & DC)

Transient

ANSI/IEEE C37.90.1-1989

 

 

Output

 

Signal Range

0-5V

Current Limit

8mA

Voltage Limit

±18V

Resistance

50Ω

Protection

Continuous Short to Ground

Ripple and Noise (100Khz)

0.025% Span rms

 

 

Accuracy(2)(3)

 

Sinusoid

±0.25% Span

50/60 Hz

45Hz to 1kHz

±0.25% Reading Additional Factor

1kHz to 20kHz

±0.75% Reading Additional Factor

Non-Sinusoid

±0.05% Reading Additional Error

Crest Factor = 1 to 2

Crest Factor = 2 to 3

±0.15% Reading Additional Error

Crest Factor = 3 to 4

±0.30% Reading Additional Error

Crest Factor = 4 to 5

±0.40% Reading Additional Error

Vs. Temperature

±100ppm/°C

 

 

Isolation (Common Mode)

 

Input to Output, Input to Power

 

Continuous

1500Vrms max

Transient

ANSI/IEEE C37.90.1-1989

Output to Power

 

Continuous

50Vdc max

 

 

Rejection (50-60Hz Common Mode)

100dB

 

 

Response Time (0 to 99%)

<400ms

 

 

Output Enable Control

6.0∝S @ CLOAD = 0 to 2000pF

Selection Time

Voltage

 

Max Logic “0”

+0.8V

Min / Max Logic “1”

+2.4V / +36V

Current, “0,1”

0.5∝A

 

 

Loop Voltage

+7.5Vdc min, +26Vdc max

Load Resistance (maximum)

(Loop Voltage - 14) / (Loop Current)

 

 

Supply Voltage

+5VDC ±5%

Current

30mA

Sensitivity

±200ppm/%

 

 

Environmental

 

Operating Temp. Range

-40˚ C to +85˚ C

Storage Temp. Range

-40˚ C to +85˚ C

Relative Humidity

0 to 90% noncondensing

Emissions

EN50081-1, ISM Group 1, Class A (Radiated, Conducted)

Immunity

EN50082-1, ISM Group 1, Class A (ESD, RF, EFT)

Dimensions

2.28" x 2.26" x 0.60" (58mm x 57mm x 15mm)

 

 

NOTE:

(1)Module rating only. Backpanel connector rating may differ — use the lowest of the two in accordance with required safety requirements.

(2)At standard 60Hz factory calibration. Consult factory for calibration at other frequencies.

(3)For 10-100% rated span. Add an additional 0.25% error for 0-10% Span measurements. Accuracy includes nonlinearity, hysteresis and repeatability but not source or external shunt inaccuracy (if used).

ORDERING INFORMATION

MODEL

INPUT* (rms)

OUTPUT* (dc)

OM5-IAC-100B-C

0-100mV

0-5V

OM5-IAC-1B-C

0-1V

0-5V

OM5-IAC-10B-C

0-10V

0-5V

 

 

 

*Modules can be ordered with other input/output ranges. Consult factory for ordering details and specifications.

9

Page 41 Page 43
Image 42
Page 41 Page 43
Contents Page OMEGAnetSM On-Line Service Internet e-mail Info@omega.com Table of Contents OM5-WMV/WV Analog Voltage Input Modules, Wide BandwidthOrdering Information OM5-WMV OM5-WVWire Transmitter Interface Modules OM5-TXModel Inputrange Outputrange OM5-TXOM5-DT General Purpose Input Modules, with DC ExcitationModel Maximum Input Output OM5-DTOM5-IFI Frequency Input ModulesOM5-IFI-1K-C OM5-IFI-3K-COM5-IFI-5K-C OM5-LTC Linearized Thermocouple Input ModulesOM5-LTC-J3-C OM5-LTC-J1-COM5-LTC-J2-C OM5-LTC-J4-COM5-AV Voltage Output ModulesPoles of Filtering Model Inputrange OM5-AVModule Dimensions and Pinouts OM5Accessories For OM5 Analog Modules SpecificationsSchematic Fusing P1 and P2 ConnectorPower Adjacent Channel JumpersOM5-BP-16-MUX-C Analog I/O Backpanel OM5-BP-16-MUX-C Schematic P1 Connector Address Selection15, Expanded OM7-DIN-SF OM7-DIN-SEOM7-DIN-CP OM5-BP-2-C Schematic OM5-BP-8-C 8 Position Analog I/O BACKPANEL, NON-MULTIPLEXED BP-8-C Schematic OM5-BP-8-MUX-C 8 Position Analog I/O BACKPANEL, Multiplexed OM5-BP-8-MUX-C OMX-1363-C 19 Inch Metal Mounting Rack OM5-BP-SKT-C Analog Module Evaluation Board OM5-1315-XX-C, OMX-CAB-01-C Interface Cables OMX-CAB-01-COMX-CJC-C Encapsulated Cold Junction Compensation OMX-955-C, OMX-955-220-C Power Supplies OMX-977-C, OMX-977-220-C Power Supplies European EMC Directive Compliant Designed for Industrial Plant EnvironmentsRTD Alpha Coefficients OM5-IMV/IV Analog Voltage Input Modules, Narrow BandwidthModel Input Range Output Range Accepts Milliamp Level Signals High Level Voltage Outputs OM5-IIAnalog Current Input Modules Model Input Range Output Range Bandwidth OM5-IIInterfaces RMS Voltage 0 300V or RMS Current 0 5A OM5-IACIsolated True RMS Input Modules Vrms Continuous Transformer Based IsolationModel OM5-IAC-1B-COM5-IAC Linearized 2- or 3-Wire RTD Input Modules Linearizes RTD Signal High Level Voltage OutputsOM5-IP/IC/IN OM5-IP/IC/IN Model Input RangeOM5-IP4/IC4/IN4 Linearized 4-Wire RTD Input Modules OM5-IP4/IC4/IN4 Block DiagramOM5-IP4/IC4/IN4 ModelOM5-PT Potentiometer Input ModulesModel Input Range OM5-PTOM5-ITC Thermocouple Input ModulesModel Type Input Range ACCURACY1OM5-WBS Strain Gage Input Modules, Wide BandwidthOrdering Input Range ExcitationUnipolar or Bipolar Current Output OM5-IVICurrent Output Modules Accepts High Level Voltage or Process Current InputInput Range Output Range Bandwidth WARRANTY/DISCLAIMER PurchasedTemperature

OM5-C specifications

Introducing the Omega Vehicle Security OM5-C, a cutting-edge vehicle security system designed to provide unparalleled protection against theft and unauthorized access. The OM5-C is engineered for modern vehicles, integrating advanced technologies to safeguard your investment while enhancing convenience and peace of mind.

One of the standout features of the OM5-C is its advanced immobilizer technology. This feature ensures that even if a thief manages to access your vehicle, they will be unable to start the engine without the proper authentication. The OM5-C uses a sophisticated algorithm that communicates with a unique key fob, making it virtually impossible for unauthorized users to bypass the system.

Another significant characteristic of the Omega Vehicle Security OM5-C is its real-time GPS tracking system. Users can remotely monitor their vehicle's location through a dedicated mobile app, which allows for instant alerts if your vehicle is moved without authorization. This not only aids in recovery in the event of theft but also provides peace of mind knowing you can always keep an eye on your vehicle’s whereabouts.

The OM5-C also boasts motion sensors that can detect any unauthorized movement, triggering an alarm to deter potential thieves. In addition, the system features advanced diagnostic capabilities, allowing users to receive notifications about the status of various vehicle components, further ensuring that everything is functioning within normal parameters.

In terms of installation, the Omega Vehicle Security OM5-C is designed for ease and efficiency. It can be installed in a wide variety of vehicles, making it versatile for different types of users. The system is compatible with both standard and luxury vehicles, ensuring comprehensive security solutions for everyone.

The user-friendly interface provided by the OM5-C mobile app allows for easy customization of alerts and settings, allowing users to tailor the system to their specific needs. Users can seamlessly manage alarm settings, track vehicle movements, and even pre-load emergency contacts directly from their smartphones.

Overall, the Omega Vehicle Security OM5-C stands out as a premier choice for vehicle protection, combining innovative technology with user-centric features. This state-of-the-art security system not only defends against theft but also enhances the overall security experience for vehicle owners, making it an invaluable investment for safeguarding automobiles.
Top Page Image Contents