1.Refer to Figures 3-1 through 3-3. Perform Steps 1, 2 and 3 in Section 3.3.1 to put the first pump on the face of the motor.
2.Refer to Figure 3-5 and Figure B. Make sure the second pump is in the closed position.
3.Refer to Figure 3-6 and Figure B. Place the blade of the flathead screwdriver in the groove of the Rotor Shaft (5) of the second pump. Rotate the Rotor Shaft of the second pump until it’s back tab slips into the groove of the Rotor Shaft of the first pump.
4.Refer to Figure 3-7. With the pumps and motor aligned, insert the optional LONG mounting screws through the mounting holes in both pumps, until they make contact with the threaded mounting holes in the motor.
5.Tighten the long screws fully with a small flathead screwdriver.
For technical details on stacking more than 2 pumps, refer to Chapter 8.
Parts of the Pump
8
(Base)
5 (Rotor Shaft)
Figure B
