Omega Vehicle Security FPU500 manual Maintenance, Introduction

6

Maintenance

6.1Introduction

•No lubrication is required for the pump. All bearings are pre-sealed and rated for long life.

•After many hours of use, fine particles of tubing will tend to accumulate inside the pump and on the rollers. Use a high pressure air hose (60 PSI) to blow out most of the particles from the pump. Clean all parts with a mild soap solution or a light mineral oil.

•The pump may be dismantled either for cleaning or for replacing the rotor assembly in case of a malfunction. Follow the procedure in Section 6.2 to replace the rotor assembly.

6-1