Omega Vehicle Security FPU500 manual Check motor fuse

		Troubleshooting Guide	7
Problem		Solution
Motor will not turn	1.	Make sure the tubing is loaded
		properly. The tubing should be
		centered in the middle of the rollers.
		Reload if necessary.
	2.	Check to see if the motor is turned
		on.
	3.	Check motor fuse.

Motor will not turn – overcurrent condition

1.Make sure the tubing is loaded properly. The tubing should be centered in the middle of the rollers.

2.Make sure the tubing wall thickness is correct (refer to Table 9-1).

3.The tubing durometer may be too high for the pump (refer to Chapter 9).

4.The tubing may be caught on the bottom roller. Reposition the roller slightly and load the tubing again.

The pump will not stay on the motor

1.The pump is not properly mounted to the motor. Refer to Section 3.

2.The mounting screws are loose. Tighten the screws, if necessary.

7-3