Baumatic BDW13 manual Error Codes What They Mean

BAUMATIC BDW13, BDW14 dishwasher user manual 24

ERROR CODES - WHAT THEY MEAN

*YOUR DISHWASHER MAY EXPERIENCE A FAULT. SHOULD THIS HAPPEN, A CODE CONSISTING OF ‘E’ & A NUMBER FROM 1-7 CAN BE DISPLAYED.

USE THIS TABLE TO UNDERSTAND WHAT IS WRONG.

*NOTE*: ALWAYS CALL FOR A Baumatic Ltd ENDORSED / APPROVED

SERVICE TECHNICIAN TO CARRY OUT REPAIRS.

CODE

SYMPTOM:

CAUSE:

WHAT TO DO:

‘E1’	LONGER FILL TIME.	FAUCET IS NOT OPENED.	Ensure that inlet hose is not
			kinked or crushed.
‘E2’		THE DRAIN PIPE WAS PLACED	Ensure drainage system is as
	LONGER or EXTENDED DRAINING TIME	TOO HIGH WHEN IT WAS	per manual and not
		INSTALLED.	extended.
‘E3’	LONGER HEATING TIME – NOT	MALFUNCTION OF	CALL FOR A QUALIFIED
		TEMPERATURE SENSOR OR OF
	REACHING REQUIRED TEMPERATURE		SERVICE TECHNICIAN.
		HEATING ELEMENT.
		TOO MUCH INLET WATER.
			Overdosing. 3-in-1 put in
		*NOTE * - THERE ARE	with salt and/or rinse aid in
			the appliance =overdose.
‘E4’		NUMEROUS CAUSES OF AN ‘E4’
	OVERFILLED
		MESSAGE. REFER TO
		APPLIANCE USAGE SECTION
		OF THIS MANUAL FOR
		GUIDELINES ON HOW TO	Could also be a Water
		PREVENT AN OVERFILL.
			Pressure problem.
		LOW VOLTAGE OR POWER
‘E5’	SWITCH CANNOT SHUT OFF	SWITCH FAILURE.
			CALL FOR A QUALIFIED
*	AUTOMATICALLY – PROGRAM NOT	*** NOTE – YOU WILL NOT	SERVICE TECHNICIAN.
	FINISHING ITS CYCLE.
		RUN INTO THIS ERROR ON THE
		BDW13/14/15 MODELS ****
‘E6’	OPEN CIRCUIT	THERMISTOR.	CALL FOR A QUALIFIED
			SERVICE TECHNICIAN.
‘E7’	SHORT CIRCUIT	THERMISTOR.	CALL FOR A QUALIFIED
			SERVICE TECHNICIAN.

WARNING!

IF OVERFLOW OCCURS, TURN OFF THE MAIN WATER SUPPLY BEFORE CALLING A SERVICE TECHNICIAN. IF THERE IS WATER IN THE BASE OF THE TANK PAN BECAUSE OF AN OVERFILL OR SMALL LEAK, THE WATER SHOULD BE REMOVED BEFORE RESTARTING THE DISHWASHER.

24