d) Connecting to the mains water supply
IMPORTANT: Do not connect the appliance to your mains water supply using an old or an existing water inlet hose. The inlet hose supplied with the dishwasher is the ONLY one that should be used.
DO NOT CONNECT THE WATER INLET HOSE TO A HOT WATER TAP.
oThe inlet hose will be located inside the cabinet of the dishwasher.
oConnect the water inlet hose to a threaded water tap that has a 3/4” thread. o Fully tighten the inlet hose to the water tap.
IMPORTANT: If the inlet hose is fitted with an aqua stop. This MUST be fitted in the upright position, as shown in the above diagram.
e) Connecting the drain hose
9Secure the drain hose, so that it cannot move whilst the dishwasher is in use.
9Place the end of the drain hose on your drain pipe. Push it a short way down into your drain pipe.
9IMPORTANT: Do not insert the drain hose too deeply into the water pipe, as this may cause siphoning.
9NEVER EXTEND THE DRAINAGE HOSE FROM ITS ORIGINAL LENGTH.
30