BAUMATIC BDW13, BDW14 dishwasher user manual | 32 |
g)NOW, PUT THE DISHWASHER ON THE SLIDE
RAILS (These are supplied so your appliance can be pushed into place
easily and to protect your floor surface from pressure points). See figure at bottom of page.
h)THEN, APPLY THE CONDENSATION STRIP.
The Condensation Strip must be fitted to the underside of the worktop above your dishwasher to protect it against any moisture. Its purpose is to deflect steam rising from your appliance to protect your worktop’s underside.
•The strip is located inside your dishwasher.
•Ensure the surface is clean prior to sticking to underside of the worktop.
•Separate the backing paper from the strip.
•Stick to the underside of the worktop.
Note: Failure to attach strip could result in damage to the underside of your work surface!
i)NOW YOU ARE READY TO PUSH THE DISHWASHER INTO POSITION (SEE FIGURE BELOW):
NOTE –
MAKE SURE YOU HAVE THE DISHWASHER ON ITS SLIDE RAILS (STEP 4 IN ILLUSTRATION ON RIGHT).
THEN MOVE IT INTO THE CABINET
RECESS (AS PICTURED ON RIGHT).
ENSURING THAT IT IS BACKED UP
AGAINST THE WALL. ATTACH THE
FURNITURE DOOR (STEP 1 AS
PICTURED ON RIGHT) IF YOU HAVE
NOT ALREADY DONE SO.
YOU ARE NOW READY TO SECURE
YOUR APPLIANCE TO THE CABINET
AREA (STEP 8 AS PICTURED ON
RIGHT) & (STEPS 2 & 7 AS PICTURED
ON RIGHT).
SEE p. 33 FOR FURTHER
INSTRUCTIONS AS TO HOW TO
ACCOMPLISH THESE.
32