Changing the wash program
IMPORTANT: This should only be attempted when the cycle has only just started, otherwise the detergent tablet may have already released or you could have hot water escaping.
oSlightly open the door of the appliance and turn off the power using the ON/OFF button.
oWait for a minute before fully opening the door of the appliance.
oTurn the appliance on by using the ON/OFF button and wait for 5 seconds before pressing the program selection button.
oPress and hold down the program selection button for 3 seconds to cancel the wash program. Then use the program selection button to choose the correct wash program.
oSelect any program options that you want to use (e.g. delay start).
oClose the door firmly, so that you hear the door lock click shut.
oAfter a few seconds, you will hear the appliance begin to fill with water and the wash program will have started.
At the end of a wash program
oThe time display will flash for 8 seconds and a buzzer will sound.
oIf you have used the delay start mode, the time display will flash for 8 seconds but the buzzer will not sound.
oOpen the door of the appliance.
oUse the ON/OFF button to switch the dishwasher off and unload the dishwasher.
Setting a delay start
It is possible to delay the start of the wash program for up to a maximum of 24 hours.
oCheck whether the appliance needs rinse aid or salt adding to it.
o Pull out the top and bottom baskets, then load them in accordance with the loading instructions.
oPush the top and bottom baskets fully back into position.
23