IMPORTANT: If any other fault code appears in the display window, you should not attempt to clear it yourself and contact the Customer Care Department.
IF THE FAULT CODE REAPPEARS AFTER FOLLOWING THE ABOVE ADVICE AND CLEARING THE FAULT CODE. YOU SHOULD TURN OFF THE APPLIANCE; DISCONNECT THE APPLIANCE FROM YOUR MAINS SUPPLY. THEN ARRANGE FOR AN ENGINEER TO ATTEND THE APPLIANCE. YOU SHOULD CONTACT THE CUSTOMER CARE DEPARTMENT ON TELEPHONE NUMBER (0118) 933 6911.
IF AN ENGINEER ATTENDS DURING THE GUARANTEE PERIOD AND FINDS THAT A FAULT HAS BEEN CAUSED BY AN ITEM ON THE ERROR CODE LIST, WHICH COULD HAVE BEEN CLEARED BY THE CUSTOMER. THEN YOU MAY BE LIABLE FOR THE COST OF THE SERVICE CALL.
General troubleshooting
PROBLEM | POSSIBLE | WHAT TO DO |
| CAUSES |
|
Dishwasher | Fuse blown or the | Replace the fuse or reset the circuit |
doesn’t | circuit breaker has | breaker. Remove any other |
run | tripped | appliances that are sharing the same |
|
| circuit with the dishwasher. |
| Power supply is not | Make sure that the dishwasher is |
| switched on | turned on and that the door is closed |
|
| securely. |
|
| Make sure that the power cord is |
|
| fully plugged into the wall socket. |
| Water pressure is | Check that the water supply is |
| low | connected properly and that the |
|
| water is turned on. |
Drain pump | Overflow | The system is designed to detect an |
doesn’t stop |
| overflow. If it does, then it will run |
|
| the drain pump continuously when |
|
| there is power to the appliance. |
Noise | Some audible sounds | You will get a level of operating noise |
| are normal | during a wash cycle, in particular |
|
| when food is being removed from |
|
| items and when the detergent |
|
| dispenser places the tablet into the |
|
| tub. |
|
|
|
31