ASRock p4i65pe manual Floppy Configuration, Super IO Configuration, OnBoard Floppy Controller

Page 29

3.3.6 Floppy Configuration

In this section, you may configure the type of your floppy drive.

BIOS SETUP UTILITY

Advanced

Floppy Configuration

Floppy A

[1.44 MB 312"]

Floppy B

[Disabled]

Select the type of floppy drive connected to the system.

Select Screen

Select Item

+- Change Option

F1 General Help

F9 Load Defaults

F10 Save and Exit ESC Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

3.3.7 Super IO Configuration

BIOS SETUP UTILITY

Advanced

Configure Super IO Chipset

OnBoard Floppy Controller

[Enabled]

Serial Port Address

[3F8 / IRQ4]

Infrared Port Address

[Disabled]

Parallel Port Address

[378]

Parallel Port Mode

[ECP + EPP]

EPP Version

[1.9]

ECP Mode DMA Channel

[DMA3]

Parallel Port IRQ

[IRQ7]

OnBoard Game Port

[Enabled]

OnBoard MIDI Port

[Disabled]

Allow BIOS to Enable or Disable Floppy Controller.

Select Screen

Select Item

+- Change Option

F1 General Help

F9 Load Defaults

F10 Save and Exit ESC Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

OnBoard Floppy Controller

Use this item to enable or disable floppy drive controller.

Serial Port Address

Use this item to set the address for the onboard serial port or disable it. Configuration options: [Disabled], [3F8 / IRQ4], [2F8 / IRQ3], [3E8 / IRQ4], [2E8 / IRQ3].

Infrared Port Address

Use this item to set the address for the onboard infrared port or disable it. Configuration options: [Disabled], [2F8 / IRQ3], and [2E8 / IRQ3].

2 9

Image 29
Contents P4i65PE Disclaimer Copyright NoticeContents Software Support Introduction Package ContentsSpecifications Bios 20.8cm 8.2 Motherboard LayoutTable for Audio Output Connection ASRock 8CH I/OPre-installation Precautions InstallationInstallation of CPU Fan and Heatsink CPU InstallationDual Channel Memory Configurations Installation of Memory Modules DimmNotch break Installing a DimmExpansion Slots PCI and AGP Slots Installing an expansion cardPS2USBPWR1 Jumpers SetupIDE2 Onboard Headers and ConnectorsUSB 2.0 Header Chassis Speaker Header Serial ATA Sata Hard Disks Installation Bios Menu Bar Bios Setup UtilityAdvanced Screen Navigation KeysMain Screen CPU Host Frequency CPU ConfigurationSpread Spectrum Ratio StatusChipset Configuration Dram RAS# to CAS# Delay Configure Dram Timing by SPDDram Precharge Delay Dram FrequencyAcpi Configuration OnBoard IDE Operate Mode IDE ConfigurationCombined Mode Option OnBoard IDE ControllerLBA/Large Mode IDE Device ConfigurationPCIPnP Configuration Super IO Configuration Floppy ConfigurationOnBoard Floppy Controller Serial Port AddressECP Mode DMA Channel Parallel Port ModeParallel Port Address EPP VersionHardware Health Event Monitoring Screen USB ConfigurationUSB Controller USB 2.0 SupportBoot Settings Configuration Boot ScreenBoot From Network Boot Up Num-LockHDD PM-MAXTOR 6L08 Boot Device PrioritySecurity Screen Exit Screen Load Optimal DefaultsSave Changes and Exit Discard Changes and ExitSoftware Support